In my particular network the configuration is the following (RPI is on 192.168.1. On my Mac I used Chicken of the VNC to connect to RPI. But when it gets plugged back into the pi, fldigi on the pi cannot decode, even though all the RTTY settings are the same across the pi and my PC. #Insert your favoured settings for a VNC session I have it installed, working very well, but there are some issues I need to resolve before it's complete. Sudo /usr/sbin/update-rc.d vnc defaults - to install the script for boot Hello Genius Pi programmers (and barely literate users like myself ) I am setting up a Pi2 for use with Amateur Radio digital modes, using a program called Fldigi. Sudo chmod +x /etc/init.d/vnc - to make the script runnable Sudo vi /etc/init.d/vnc - to create a startup script Sudo apt-get install tightvncserver - to install VNC server I used the following steps to get VNC working: I connected LAN cable from my router and checked that I had proper IP address via /sbin/ifconfig command. You can do this even before powering up with SD card mounted on another computer and just renaming the file. ![]() ![]() Enabling SSH is as simple as renaming the "boot_enable_ssh.rc" to "boot.rc" in the /boot directory. I wanted to have access to this tiny computer via SSH and VNC remotely over the network. One of the first objectives was to configure RPI in headless mode. A familiar Linux bootup screen appeared and after entering the default username "pi" and password "raspberry" I was logged in.ĬONFIGURING RASPBERRY PI IN HEADLESS MODE This Blog is mainly dedicated to Amateur Radio (Ham radio) and contains external articles and personal esperiences.After quick visual inspection everything looked OK so I inserted the SD card into socket, connected HDMI cable to my display, keyboard cable to USB socket and plugged a Nokia USB cellphone charger to power up this latest toy. IT System Engineer, recently started having fun with morse code and Raspberry Pi Licensed Amateur Radio operator in 1996 as IW5EDI, active member of ARI Firenze and ARRLĬlass 1970, married with two childrens, love experimenting and antenna home-brewing. On the Raspberry you need to configure the connection with the USB to Serial cable connected to the RS-232 port of the TS-590S. Basically FLRG acts as a gateway to your radio. On the MAC you need to reconfigure the programs, in order to use FLRIG as Radio. FLDIGI for common digital modes and WSJT-X for weak signals digital modes. I’m using RUMLOG by DL2RUM as main logging program both as main logging and for contest logging as well. Transmitting RDFT on a Raspberry Pi can be difficult, therefore using a simple FM transmission of THOR8 or QPSK256 should be adequate using FLDIGI should. ![]() Additionally remote connection from the internet requires a PC always turned on or at least the possibilty to power on with wake-on-lanĪn alternative solution is to run the FLRIG on the iMac, and connect the applications to the local loopback 127.0.0.1. ![]() This allows me to control the Kenwood TS-590S from the iMac simultaneously with several applications, including RUMLOG, FLDIGI, WSJT-X.Ĭould not control simultaneously my transceiver directly from two or more applications. I’ve recently introduced a Raspberry PI 4 as main remote RTX controller for my Kenwood TS-590s.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |